Text bar

You can find this control at Slider settings → Controls tab.

You can show your active slide's title and description on a bar.

⚠️ Warning: This control isn't available at the Carousel Pro slider type! If you want to have a caption at each slide, use layers instead!

Horizontal

Position

Pick a position, where you would like to have your bar in your slider.

  • Stack - The order of the controls, which you put into the same position.
  • Offset - This is how far your bar will be from the selected position. If you change to Advanced Pro mode, you can specify the position, and here you will be able to use our control variables too.
Animate

You can turn on a simple fade out/fade in animation, if you want to.

Bar style

You can style your Text bar here, choose its colors for Normal state, make it bigger or smaller, etc...

Title
  • Shows - You can set whether to show the description or not.
  • Font - pick the description font here
Description
  • Shows - You can set whether to show the description or not.
  • Font - pick the description font here
Slide count

The title and the description can be replaced with the index of the current slide and slide count. For example with 6 slides, the 1st slide would show this (you can change the separator): 1/6

Width Pro

The length of the bar.

Full width

If you want to specify your bar's width, turn this on. When it's turned off, your bar's width will be just as much as it needs for your title's text.

Separator

This is the text between the title and the description in the bar to separate them.

💡 Tip

Use <br> to break the Title and Description to two lines.

Align

You can align your text in your bar.

Shows on hover

This option will make your text bar only appear on desktop screen, when you hover your cursor over the slider. On tablet and mobile screen they will always be seen.

Hide on

You can make your text bar invisible on Desktop, Tablet or Mobile view.

Hide on slides Pro

You can hide your text bar on specific slides separated by commas. Use the slide index (1 = first slide) instead of the slide ID.

Vertical Pro

Height

The height of the bar.

☝️ Note: The description of the other settings can be found above.
Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.